FAQ
What do I need to install?
Section titled “What do I need to install?”A Rocky Linux 10.2 (x86_64) host, sudo, 8 GB of memory or more, 20 GB free on /, an existing interface to name as the provider NIC, the provider network values (CIDR, gateway, floating range) and internet access. See Before you install.
Do I have to build the OpenStack RPMs?
Section titled “Do I have to build the OpenStack RPMs?”No. With the release, the installer downloads the prebuilt RPMs from GitHub Releases and verifies them. Use --rpm-source build only if you want to build from source (it takes hours).
What differs between GCE and on-premises?
Section titled “What differs between GCE and on-premises?”- GCE: VMs run inside a VM, so the instance needs nested virtualisation. Allow the traffic between nodes in the VPC firewall rules. HAGISTACK’s acceptance tests ran on GCE (nested KVM).
- On-premises: enable hardware virtualisation in the BIOS/UEFI and let the required ports through the firewalls and switches between nodes. Reaching floating IPs from a physical LAN needs the provider NIC attached to
br-exby you; that setup is not verified.
I cannot reach Horizon
Section titled “I cannot reach Horizon”The URL is http://MGMT_IP/dashboard/. Check that httpd runs and that the browser reaches port 80 of the management IP (firewalld and the like). See Troubleshooting.
My VM does not boot
Section titled “My VM does not boot”openstack server show VM_NAME -c fault shows the error. For No valid host was found, check that nova-compute is up and that there are enough free resources. See Troubleshooting.
I cannot SSH to my VM
Section titled “I cannot SSH to my VM”A floating IP is not reachable from the physical LAN as it is. Connect to the tenant address from the metadata namespace, or give the host’s br-ex the provider gateway address (Your first VM). The user is cirros, the key /etc/hagistack/hagistack-key.
Can I use the noVNC console?
Section titled “Can I use the noVNC console?”Not with the release rocky10.2-rpms-2026.1. Horizon’s console tab does not work.
noVNC support is in development for the next release and has not been accepted on a real deployment yet (noVNC console (in development)).
How many compute nodes can I add?
Section titled “How many compute nodes can I add?”compute-add can be repeated, but only one added compute node (two nodes in all) is verified. Three or more nodes are not verified.
Can SELinux be enforcing?
Section titled “Can SELinux be enforcing?”Not verified. HAGISTACK switches SELinux to permissive and installs no OpenStack SELinux policy (openstack-selinux).